IP113A / IP113C 10/100Base-TX / FX Media Converter
General Description :
IP113A can be a 10/100BASE-TX to 100BASE-FX converter or a 100BASE-FX to 100BASE-FX repeater with an SMI port for management. It consists of a 2-port switch controller, a fast Ethernet transceiver and a PHY for 100BASE-FX. The transceivers in IP113A are designed in DSP approach with advance 0.25um technology; this results in high noise immunity and robust performance.
IP113A not only supports store and forward mode, IP113A also supports modified cut through mode and pure converter mode for low latency data forwarding. IP113A can transmit packet(s) up to 1600 bytes to meet requirement of extra long packets.
IP113A supports IEEE802.3x, collision base backpressure, and various LED functions, etc. These functions can be configured to fit the different requirements by feeding operation parameters via EEPROM interface or pull up/down resistors on specified pins.
Feature :
A 10/100BASE-TX/100BASE-FX converter
Built in a 10/100BASE-TX transceiver
Built in a PHY for 100BASE-FX
Built in a 2-port switch
- Pass all packets without address and CRC check (optional)
- Supports modified cut-through frame forwarding for low latency
- Supports pure converter mode data forwarding for extreme low latency
- Supports flow control for full and half duplex operation
- Bandwidth control
- Forward 1600 bytes packet for management
- Optional forward fragments
Built in 128Kb RAM for data buffer
Supports auto MDI-MDIX function
Supports link fault pass through function
Supports far end fault function
LED display for link/activity, full/half, 10/100
Built in a watchdog timer to monitor internal switch error
Supports EEPROM Configuration
0.25um CMOS technology
Single 2.5v power supply 48-pin LQFP package
48-pin LQFP package |
免责声明： 以上所展示的信息由会员自行提供，内容的真实性、准确性和合法性由发布会员负责，企业录对此不承担任何责任。如有侵犯您的权益，请来信通知删除。